Back Blaster

Hi, today I’m going to share with you one of my favorite routines. My back day routine the sets and reps can be modified as you I like to do 5 sets of 5 reps on all of my exercises.

As a warm up I like to do a static stretch then, knock out some pull ups I usually do about 25 pull ups. This may be a lot for some of you, so just look for a good number that’s not going to push you too hard but will warm up your muscles.

51.jpg

First exercise Deadlift

  1. Begin standing with a barbell close to your shins. Your feet should be directly under your hips with your feet turned out slightly. Grip the bar with a double overhand grip or hook grip, about shoulder width apart. Squat down to the bar. Your spine should be in full extension, with a back angle that places your shoulders in front of the bar and your back as vertical as possible.
  2. Begin by driving through the floor through the front of your heels. As the bar travels upward, maintain a constant back angle. Flare your knees out to the side to help keep them out of the bar’s path.
  3. After the bar crosses the knees, complete the lift by driving the hips into the bar until your hips and knees are extended.

50.jpg

Bent over row

  1. Holding a barbell with a pronated grip (palms facing down), bend your knees slightly and bring your torso forward, by bending at the waist, while keeping the back straight until it is almost parallel to the floor. Tip: Make sure that you keep the head up. The barbell should hang directly in front of you as your arms hang perpendicular to the floor and your torso. This is your starting position.
  2. Now, while keeping the torso stationary, breathe out and lift the barbell to you. Keep the elbows close to the body and only use the forearms to hold the weight. At the top contracted position, squeeze the back muscles and hold for a brief pause.
  3. Then inhale and slowly lower the barbell back to the starting position.
  4. Repeat for the recommended amount of repetitions.

Lat Pulldown

  1. Sit down on a pull-down machine with a wide bar attached to the top pulley. Make sure that you adjust the knee pad of the machine to fit your height. These pads will prevent your body from being raised by the resistance attached to the bar.
  2. Grab the bar with the palms facing forward using the prescribed grip. Note on grips: For a wide grip, your hands need to be spaced out at a distance wider than shoulder width. For a medium grip, your hands need to be spaced out at a distance equal to your shoulder width and for a close grip at a distance smaller than your shoulder width.
  3. As you have both arms extended in front of you holding the bar at the chosen grip width, bring your torso back around 30 degrees or so while creating a curvature on your lower back and sticking your chest out. This is your starting position.
  4. As you breathe out, bring the bar down until it touches your upper chest by drawing the shoulders and the upper arms down and back.Tip: Concentrate on squeezing the back muscles once you reach the full contracted position. The upper torso should remain stationary and only the arms should move. The forearms should do no other work except for holding the bar; therefore do not try to pull down the bar using the forearms.
  5. After a second at the contracted position squeezing your shoulder blades together, slowly raise the bar back to the starting position when your arms are fully extended and the lats are fully stretched. Inhale during this portion of the movement.
  6. Repeat this motion for the prescribed amount of repetitions.

Romanian Deadlift

  1. Hold a bar at hip level with a pronated (palms facing down) grip. Your shoulders should be back, your back arched, and your knees slightly bent. This will be your starting position.
  2. Lower the bar by moving your butt back as far as you can. Keep the bar close to your body, your head looking forward, and your shoulders back. Done correctly, you should reach the maximum range of your hamstring flexibility just below the knee. Any further movement will be compensation and should be avoided for this movement.
  3. At the bottom of your range of motion, return the starting position by driving the hips forward to stand up tall.

49.jpg

Finally, Barbell curl

  1. Stand up with your torso upright while holding a barbell at a shoulder-width grip. The palm of your hands should be facing forward and the elbows should be close to the torso. This will be your starting position.
  2. While holding the upper arms stationary, curl the weights forward while contracting the biceps as you breathe out. Tip: Only the forearms should move.
  3. Continue the movement until your biceps are fully contracted and the bar is at shoulder level. Hold the contracted position for a second and squeeze the biceps hard.
  4. Slowly begin to bring the bar back to starting position as your breathe in.
  5. Repeat for the recommended amount of repetitions.

If you have any questions, concerns, or would like additional workouts comment below; and PLEASE FOLLOW!!!

CITATIONS http://www.bodybuilding.com/exercises/detail/view/name/clean-deadlift

http://www.bodybuilding.com/exercises/detail/view/name/bent-over-barbell-row

http://www.bodybuilding.com/exercises/detail/view/name/wide-grip-lat-pulldown

http://www.bodybuilding.com/exercises/detail/view/name/romanian-deadlift

http://www.bodybuilding.com/exercises/detail/view/name/barbell-curl

One thought on “Back Blaster

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s